From the bloggers at Travel With Kevin and Ruth.
First thing I did yesterday morning was to change Sherman’s distributor cap and rotor. Should have been a simple half hour job from start to finish, but it didn’t go that smoothly. The distributor cap is held on with two long skinny screws, about 3/4″ long. One of them snapped in two taking the old cap off. That’s not supposed to happen!
After pondering my choices (one of which was to wait until the world’s smallest Canadian Tire opened it’s doors at noon) I tried putting the new cap on with just the one screw. There’s a guide on both sides of it, and it seemed to hold just fine with only the one screw. So rather than sitting and waiting for three hours, we got on the road. I’ll fix it properly in Ottawa.
To read the full story by Travel With Kevin and Ruth, click here.