Thursday , August 24 2017
Home / General RV / Techno RV: How to install a new sensor on a TireTraker tire pressure monitoring system
Monitor

Techno RV: How to install a new sensor on a TireTraker tire pressure monitoring system

From the bloggers at Techno RV.

There are many reasons you may need to install a new sensor on a TireTraker Tire Pressure Monitoring System. Maybe you have a new rig and you want to transfer the sensors from your old rig. If you are installing a signal booster, it is recommended that you delete all sensors and reinstall them.

Another reason might be that you have experienced a faulty sensor and you need to replace it with a new one.  In all of these cases, simply unscrewing the old sensors and screwing on the new ones won’t work because the monitor is still keyed to the old sensors. You need to uninstall the old sensors and reinstall the new ones. Here’s how you do that:

Installing a New Sensor on a TireTraker Tire Pressure Monitoring System:

Make sure the unit is turned on, and remove the sensors from the tires that you want to delete. Then go into the programming mode by pressing and holding the left and right buttons simultaneously until the monitor beeps.

To read the full story by Techno RV, click here.

About Best of the Web

Leave a Reply

Pin It on Pinterest